SATO HR2 Series - Page 57

Section 3: Operation and Configuration
HR2 Series Operator Manual Page 3-17
3.7 INTERFACE MODE (Cont’d)
INTERFACE MODE
Menu Description
Select the connected interface to be used as Sub Port.
NONE, RS-232C, USB or LAN can be selected. The initial cursor position is at
NONE.
Notes:
•The interface which already set for DATA PORT is not able to select.
Restart the printer to enable the new settings.
This screen shows the connection setting between the Sub Port and the exter-
nal device.
ENABLE: Connecting the sub port and the external device. It’s possible to
import the data from the external port into the print data by the combination of
an extended command.
DISABLE: Not connecting the sub port and the external device. It’s possible to
monitor the printer status.
The initial setting is ENABLE.
Note: This screen is displayed only when interface (other than NONE) is
selected for SUB PORT selection.
121(