Section 3: Operation and Configuration
Page 3-16 HR2 Series Operator Manual
3.7 INTERFACE MODE (Cont’d)
1. During OFFLINE mode, press + and < button simultaneously to display the operational icon menu. Press
<, >, + or - buttons to select INTERFACE MODE.
2. When INTERFACE MODE is displayed, press the FEED button to enter to Interface mode for adjustment.
Note:
PASSWORD may prompt on the display if SET PASSWORD is set to ON in the Service mode. Please
refer to Section 3.16.5 Overview of Setting menu in Service Mode for details in password inputting.
3. Keypad CONNECT is first displayed. Press the FEED button repeatedly will switch to the next setting
options as shown above. To return to the previous setting option, press LINE button. To return to INTER-
FACE MODE screen, press and hold LINE button.
4. When the desired setting option is displayed, press <, >, + or - buttons to select the item or to set the value
and then press FEED button to save the setting.
INTERFACE MODE
Menu Description
This screen shows the connection setting of input device (Keypad).
ENABLE: If the input device is connected, print data from the device will be
valid. If the device is disconnected, print data received from the PC
will be valid.
* The data received from the PC becomes invalid while the input
device is connected.
DISABLE: Only the print data received from the PC becomes valid.
* The data received from the input device becomes invalid.
The initial cursor position is at ENABLE.
Connection status of input device can be checked by the status icon displayed
in the Normal Mode (ONLINE/ OFFLINE).
Note: Changed settings will be in effect from the next power on.
This is a confirmation screen for setting the connected interface configurations.
If YES, it goes to the PORT SELECT screen.
If NO, it returns to INTERFACE MODE menu.
The initial cursor position is at NO.
This screen allows user to select the port used for the connected interface.
Either DATA PORT or SUB PORT can be selected.
DATA PORT: It can receive various SBPL commands and it can execute print
operations.
SUB PORT: It is for monitoring printer status and connecting to external
devices.
The initial cursor position is at DATA PORT.
Select the connected interface to be used as Data Port.
One of three interfaces, LAN, RS-232C, USB can be selected. The initial cur-
sor position is at LAN.
Notes:
•You can’t select the data port when Keypad is connected to RS-232C.
•The interface which already set for SUB PORT is not able to select.
Restart the printer to enable the new settings.
To Next Page
Loading...
