SATO HR2 Series - Page 130

Section 6: Basic Specifications
Page 6-2 HR2 Series Operator Manual
Precision of print position
Dispenser
mode
Print start position:
[GAP sensor] Within ±0.3 mm (0.012")
[I-Mark sensor] Within ±1.5 mm (0.059")
Width direction: Within ±0.3 mm (0.012")
Continuous
mode
Print start position:
[GAP sensor] Within ±0.3 mm (0.012")
[I-Mark sensor] Within ±1.0 mm (0.039")
Width direction: Within ±0.3 mm (0.012")
Tear-off mode
Print start position:
[GAP sensor] Within ±0.5 mm (0.019")
[I-Mark sensor] Within ±1.5 mm (0.059")
Width direction: Within ±0.3 mm (0.012")
Operating environment: Temperature 0 to 40°C (32 to 104 F)/Humidity 10 to 80%RH
(Non-condensing)
Using precise measurement labels with ±0.2 mm (0.008") tolerance is required.
*
Using the Gap sensor will provide better print start position accuracy as
compared to using the I-Mark sensor.
The difference in label processing accu-
racy, label pitch and label detection motion may influence the accuracy of print start
position.
*The print accuracy above is tested based on specific conditions and is not guaran-
teed. Also, it does not include label assembly accuracy. Depending on label, ribbon
and label size conditions, it may not be possible to obtain the value above.
Precision of print expansion Within the range of ±1% toward paper feed direction
Unprintable area
Pitch direction
Top: 0.5 mm (0.019"), Bottom: 0.5 mm (0.019")
(Not including liner)
Width direction
Left: 0.5 mm (0.019"), Right: 0.5 mm (0.019")
(Not including liner)
MEDIA (Be sure to use media manufactured or certified by SATO)
Size
Label Continuous
Tear-off
Dispenser
Width: 7 to 58 mm (0.3" to 2.3")
Width including liner: 10 to 61 mm (0.4" to 2.4")
Pitch: 3 to 197 mm (0.1" to 7.7")
Pitch including liner: 6 to 200 mm (0.2" to 7.8")
Width: 7 to 58 mm (0.3" to 2.3")
Width including liner: 10 to 61 mm (0.4" to 2.4")
Pitch: 3 to 197 mm (0.1" to 7.7")
Pitch including liner: 6 to 200 mm (0.2" to 7.8")
Width: 7 to 58 mm (0.3" to 2.3")
Width including liner: 10 to 61 mm (0.4" to 2.4")
Pitch: 3 to 197 mm (0.1" to 7.7")
Pitch including liner: 6 to 200 mm (0.2" to 7.8")
** The above sizes are structurally possible; however, some restrictions may apply
depending on paper types, use environment and usage. Make sure to check the
paper size and corresponding print mode before operations.
Type
Thermal Transfer
Use roll media specified by SATO.
Roll Diameter Maximum outer diameter: 185 mm (7.3")
Core Diameter Inner core diameter: 76.4 mm (3.0")
Thickness Label: 0.13 to 0.220 mm (0.005" to 0.008")
Wind Direction Face-Out
PRINT