Section 3: Operation and Configuration
HR2 Series Operator Manual Page 3-65
3.16 SERVICE MODE (Cont’d)
SETTING MODE
Menu Description
Enabling/Disabling the command priority for system setting.
COMMAND: Priority is given to certain system commands that was sent to the
printer and overwrite the configuration done by the LCD operation
panel. This priority assignment affects the settings for print
darkness, print speed, start point correction, operation mode,
printer type, print method and sensor types.
INTERNAL: The above mentioned printer configuration set by the LCD
operation panel is not replaced by the sent command.
The initial setting is COMMAND.
Enabling/Disabling password entry to various modes.
ON: To enable password entry.
OFF: To disable password entry.
Requiring the password when entering the following modes.
•USER MODE •INTERFACE MODE
•CARTRIDGE MODE •ADVANCED MODE
•HEX DUMP MODE
The initial value is OFF.
Setting password to go to various modes.
Press +/- buttons to key in the number and press , arrow buttons to move
the cursor to next digit. Press FEED button to enter the setting.
Set the password in four digits.
The initial value is 0000.
Setting the display of print quantity on the normal mode screen (ONLINE/
OFFLINE).
YES: Showing the total print quantity and the current print quantity.
NO: Showing print quantity.
The initial setting is YES.
Selecting reprint of previous label.
YES: Reprints previous label.
NO: Does not perform reprinting.
In online mode when YES is set, pressing FEED button will print the previous
label.
The initial setting is NO.
Selecting external output pin number for output dispense waiting signal.
9PIN: 9PIN is changed to output by SW3 on CONT PCB.
10PIN: 10PIN is changed to output by SW3 on CONT PCB.
The initial setting is 9PIN.
Valid when ENABLE is selected in EXTERNAL DISP screen under Advanced
mode.
To Next Page
Loading...
Need help?
General
