SATO HR2 Series - Page 141

Section 7: Interface Specifications
HR2 Series Operator Manual Page 7-7
7.4.1 Basic Specifications (Cont’d)
Communication setup The following communication settings are available in the Interface Mode of the
printer.
Item Setting range
Protocol STATUS3
STATUS4 (Cyclic response mode)
STATUS4 (ENQ response mode)
STATUS5
IP address 0.0.0.0 ~ 255.255.255.255
Subnet mask 0.0.0.0 ~ 255.255.255.255
Gateway address 0.0.0.0 ~ 255.255.255.255
IP address setting DHCP Disable (Set by manual)
DHCP Enable
Default: Disable (Set by manual)
RARP setting RARP Disable
RARP Enable
Default: Disable
* IP address, Subnet mask, Gateway address can be set by printer setting tool in
the accessory CD.
Maximum receive
buffer capacity
2.95MB
Buffer near full
Buffer near full
0MB
2.95MB
Remaining 0.95MB
Remaining 1.95MB
occurred
released