Section 3: Operation and Configuration
Page 3-10 HR2 Series Operator Manual
3.4 ADJUSTMENT SCREEN (Cont’d)
Menu Description
Adjust the print speed.
Setting range is between 1.0 and 4.0IPS, and the initial value is 2.0IPS.
This setting reflects the setting of PRINT SPEED screen in USER MODE.
Command priority setting.
C: Enables Command priority setting.
I: Disables Command priority setting.
The default setting is "C".
This setting reflects the setting PRIORITY SETTING screen in SERVICE
MODE.
Adjust the print darkness of the print-out.
Setting range is 1A, 2A, 3A, 4A, 5A, 1B, 2B, 3B, 4B, 5B. (1A is the lightest
while 5B is the darkest. Default is “3A”)
This setting reflects the setting of PRINT DARKNESS screen in USER
MODE and the DARKNESS RANGE screen in ADVANCED MODE.
Setting value of the selected range is between 00 and 99, and the initial
value is 50. (00 is the lightest while 99 is the darkest.)
After setting the value of print darkness, press FEED button will save the
value and proceed to PITCH position setting if there is no remaining label to
be printed. (QTY=0)
Otherwise, the printer will return to SPEED setting screen. (QTY≠0)
Note:
It is not advisable to set the print darkness to the higher position as a darker
print-out requires the print head to operate in a higher temperature. Operat-
ing in high temperature may damage the print head in a long run.
Adjusts the print position or reference point where the printings begins verti-
cally, relative to the leading edge of each media.
Setting value is adjustable by 0.25mm (0.01") regardless of print resolution.
Setting range is ±3.75mm (±0.15") and the initial value is +0.00mm.
Adjust the stop position of each media after printing.
Setting value is adjustable by 0.25mm (0.01") regardless of print resolution.
Setting range is ±3.75mm (±0.15") and the initial value is +0.00mm.
To Next Page
Loading...
