Section 3: Operation and Configuration
Page 3-14 HR2 Series Operator Manual
3.6 USER MODE (Cont’d)
USER MODE
Menu Description
You can use this setting to determine whether zeroes are printed with a slash
across them or not. The zero slash can be set to either 0 or Ø.
If YES, [0] will be accompanied by a slash.
If NO, no slash will appear.
The initial value is NO.
* Slash zero (zero has a slash through it) is available in the following fonts:
U, S, M, WB, WL, XU, XS, XM, XB, XL, Outline font
Allows you to select character code from the following:
“JIS”: Uses JIS for Kanji code.
“SJIS”: Uses Shift JIS for Kanji code.
“Unicode”: Used Unicode for Kanji code.
The default is “JIS”.
This setting determines whether the space surrounding each text character is
of a fixed width, or whether that space is to be varied to be visually more pleas-
ant and proportional.
If selecting PROPORTIONAL, data will be printed without character spacing.
If selecting FIXED, data will be printed with fixed character spacing.
The initial value is FIXED.
To Next Page
Loading...
