Section 3: Operation and Configuration
Page 3-38 HR2 Series Operator Manual
3.13 TEST PRINT MODE (Cont’d)
*1 Condition to feed one label before test print
TEST PRINT MODE
Menu Description
Adjusting the print and offset positions.
Press +/- buttons to change the setting value and press , arrow buttons to
toggle between PITCH POSITION and OFFSET POSITION setting.
Both setting range are ±3.75mm (±0.15") and are adjustable by 0.25mm
(±0.01").
The initial value is +0.00mm.
Press FEED button to start test printing.
Adjusting the top position after power on or cover open/close.
Press +/- buttons to change the setting value and press , arrow buttons to
toggle between PITCH POSITION and OFFSET POSITION setting.
Both setting range are ±3.75mm (±0.15") and are adjustable by 0.25mm
(±0.01").
The initial value is +0.00mm.
Press FEED button to start test printing.
This screen is only displayed when SMALL PITCH and TEAR OFF are
selected.
Test print is in progress
Press FEED button while printing will pause the test print operation. Press
FEED again to continue.
Label feed before printing is performed by PRINTER TYPE selection.
Refer to following table.(*1)
No Test print item Dispense Tear Off Continuous
1FACTORY1 Starts print
after default
operation.
Feeds one label after
initial operation and
start printing.
Feeds one label after
initial operation and
start printing.
2FACTORY2
3 HEAD SENSOR
4 CONFIGURATION Start printing after ini-
tial operation.
Feeds one label after
initial operation and
start printing by setting
of [AUTO ONLINE
FEED], [FEED ON
ERROR].
Start printing after ini-
tial operation.
Feeds one label after
initial operation and
start printing by setting
of [AUTO ONLINE
FEED], [FEED ON
ERROR].
5 BARCODE
6 HEAD CHECK
7MEMORY
8FONT
9 SMALL PITCH
To Next Page
Loading...
