Schweitzer Engineering Laboratories SEL-787 - Table 4.43 Ethernet Port Settings

4.93
Date Code 20081022 Instruction Manual SEL-787 Relay
Protection and Logic Functions
Port Settings (SET P Command)
PORT F
PORT 1
Table 4.42 Front-Panel Serial Port Settings
Setting Prompt Setting Range
Setting Name :=
Fa c tor y D efa ult
PROTOCOL SEL, MOD,
EVMSG, PMU
PROTO := SEL
SPEED 300–38400 bps SPEED := 9600
DATA BITS 7, 8 bits BITS := 8
PARITY O, E, N PARITY := N
STOP BITS 1, 2 bits STOP := 1
HDWR HANDSHAKING Y, N RTSCTS := N
PORT TIME-OUT 0–30 min T_OUT := 5
SEND AUTOMESSAGE Y, N AUTO := N
MODBUS SLAVE ID 1–247 SLAVEID := 1
Table 4.43 Ethernet Port Settings
Setting Prompt Setting Range
Setting Name :=
Facto ry Default
IP ADDRESS zzz.yyy.xxx.www IPADDR := 192.168.1.2
SUBNET MASK 15 characters SUBNETM := 255.255.255.0
DEFAULT ROUTER 15 characters DEFRTR := 192.168.1.1
Enable TCP Keep-Alive (Y, N) ETCPKA := Y
TCP Keep-Alive Idle Range 1–20 sec KAIDLE := 10
TCP Keep-Alive Interval Range 1–20 sec KAINTV := 1
TCP Keep-Alive Count Range 1–20 sec KACNT := 6
OPERATING MODE FIXED, FAILOVER,
SWITCHED
NETMODE := FAILOVER
FAILOVER TIMEOUT 0.10–65.00 sec FTIME := 1.00
PRIMARY NETPORT A, B, D NETPORT := A
NETWRK PORTA SPD AUTO, 10, 100 Mbps NETASPD := AUTO
NETWRK PORTB SPD AUTO, 10, 100 Mbps NETBSPD := AUTO
TELNET PORT 23, 1025–65534 TPORT := 23
TELNET TIME OUT 1–30 min TIDLE := 15
FTP USER NAME 20 characters FTPUSER := FTPUSER
Enable IEC 61850 Protocol (Y, N) E61850 := N
Enable IEC 61850 GSE (Y, N) EGSE := N
Enable DNP Sessions
a
a
See Ta b le D .7 for a complete list of the DNP3 session settings.
0–3 EDNP := 0
IMPORTANT: Upon relay initial
power up or Port 1 setting changes or
Logic setting changes, the user may
have to wait up to two minutes before
an additional setting change can
occur. Note that the relay is functional
with protection enabled, as soon as
the ENABLED LED comes ON (about 5—10
seconds from power up).