Schweitzer Engineering Laboratories SEL-787 - Table 7.15 EVENT Command (Event Reports); Table 7.16 EVENT Command Format; Table 7.17 FILE Command

7.20
SEL-787 Relay Instruction Manual Date Code 20081022
Communications
SEL ASCII Protocol and Commands
EVENT Command (Event Reports)
Use the EVE command (see Table 7.15 and Table 7.16) to view event reports.
See Section 9: Analyzing Events for further details on retrieving and analyzing
event reports. See the HISTORY Command on page 7.23 for details on
clearing event reports.
FILE Command
The FIL command (see Table 7.17) is intended to be a safe and efficient
means of transferring files between intelligent electronic devices (IEDs) and
external support software (ESS). The FIL command ignores the hide rules and
transfers visible as well as hidden settings, except the settings hidden by a part
number.
GOOSE Command
Use the GOOSE command to display transmit and receive GOOSE
messaging information, which can be used for troubleshooting. The GOOSE
command variants and options are shown in Table 7.18.
Table 7.15 EVENT Command (Event Reports)
Command Description Access Level
EVE n Return the n event report with 4-samples/cycle data. 1
EVE n R or
EVE R n
Return the n event report with raw (unfiltered)
16 samples/cycle analog data and 4 samples/cycle
digital data.
1
EVE D n Return the n digital data event report with
4-samples/cycle data.
1
EVE D n R Return the n digital data event report with
16-samples/cycle data.
1
EVE DIF1 n Return the n differential element 1 event report, with
4-samples/cycle data.
1
EVE DIF2 n Return the n differential element 2 event report, with
4-samples/cycle data.
1
EVE DIF3 n Return the n differential element 3 event report, with
4-samples/cycle data.
1
Table 7.16 EVENT Command Format
Parameter Description
n Parameter n specifies the event report number to be returned. Use the HIS
command to determine the event report number of the event you want to
display. If n is not specified, the relay will display event report 1 by default.
Table 7.17 FILE Command
Command Description Access Level
FIL DIR Return a list of files. 1
FIL READ
filename
Transfer settings file filename from the relay to the PC. 1
FIL WRITE
filename
Transfer settings file filename from the PC to the relay. 2
FIL SHOW
filename
Filename 1 displays contents of the file filename.1