EasyManua.ls Logo

Schweitzer Engineering Laboratories SEL-787 - Page 399

Schweitzer Engineering Laboratories SEL-787
564 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
D.11
Date Code 20081022 Instruction Manual SEL-787 Relay
DNP3 Communications
DNP3 in the SEL-787
DVARAI1 Analog Input Default Variation 1–6 4
ECLASSB1 Class for binary event data, 0 disables 0–3 1
ECLASSC1 Class for counter event data, 0 disables 0–3 0
ECLASSA1 Class for analog event data, 0 disables 0–3 2
DECPLA1 Decimal places scaling for Current data 0–3 1
DECPLV1 Decimal places scaling for Voltage data 0–3 1
DECPLM1 Decimal places scaling for Miscellaneous data 0–3 1
ANADBA1 Analog reporting dead band for current; hidden if ECLASSA1 set to 0 0–32767 100
ANADBV1 Analog reporting dead band for voltages; hidden if ECLASSA1 set to 0 0–32767 100
ANADBM1 Analog reporting dead band for miscellaneous analogs; hidden if ECLASSA and
ECLASSC set to 0
0–32767 100
TIMERQ1 Time-set request interval, minutes (M = Disables time sync requests, but still accepts
and applies time syncs from Master; I = Ignores (does not apply) time syncs from
Master)
I, M, 1–32767 I
STIMEO1 Select/operate time-out, seconds 0.0–30.0 1.0
DNPINA1
a
Send Data Link Heartbeat, seconds; hidden if DNPTR1 set to UDP 0.0–7200 120
DRETRY1
b
Data link retries 0–15 3
DTIMEO1
b
Data link time-out, seconds; hidden if DRETRY1 set to 0 0.0–5.0 1
ETIMEO1 Event message confirm time-out, seconds 1–50 5
UNSOL1 Enable unsolicited reporting; hidden and set to N if ECLASSB1, ECLASSC1, and
ECLASSA1 set to 0
Y, N N
PUNSOL1 Enable unsolicited reporting at power up; hidden and set to N if UNSOL1 set to N Y, N N
NUMEVE1
c
Number of events to transmit on 1–200 10
AGEEVE1
c
Oldest event to transmit on, seconds 0.0–99999.0 2.0
URETRY1
c
Unsolicited messages maximum retry attempts 2–10 3
UTIMEO1
c
Unsolicited messages offline timeout, seconds 1–5000 60
Session 2 Settings
DNPIP2
a
IP address (zzz.yyy.xxx.www) 15 characters “”
DNPTR2
a
Transport protocol UDP, TCP TCP
·
·
·
URETRY2
a,c
Unsolicited messages maximum retry attempts 2–10 3
UTIMEO2
a,c
Unsolicited messages offline timeout, seconds 1–5000 60
Session 3 Settings
DNPIP3
a
IP address (zzz.yyy.xxx.www) 15 characters “”
DNPTR3
a
Transport protocol UDP, TCP TCP
·
·
·
URETRY3
a,c
Unsolicited messages maximum retry attempts 2–10 3
UTIMEO3
a,c
Unsolicited messages offline timeout, seconds 1–5000 60
Serial Port Settings
MINDLY
b
Minimum delay from DCD to TX, seconds 0.00–1.00 0.05
MAXDLY
b
Maximum delay from DCD to TX, seconds 0.00–1.00 0.10
PREDLY
b
Settle time from RTS on to TX; Off disables PSTDLY OFF, 0.00–30.00 0.00
PSTDLY
b
Settle time from TX to RTS off; hidden if PREDLY set to Off 0.00–30.00 0.00
a
Available only on Ethernet ports.
b
Available only on serial ports.
c
Hidden if UNSOLn set to N.
Table D.7 Port DNP3 Protocol Settings (Sheet 2 of 2)
Name Description Range Default

Table of Contents

Related product manuals