Schweitzer Engineering SEL-351P - Page 484

ii Serial Port Communications and Commands Date Code 990430
SEL-351P Manual Técnico
MET E – Energy Metering................................................................................10-24
MET M – Maximum/Minimum Metering.........................................................
10-25
QUI Command (Quit Access Level).........................................................................
10-25
SER Command (Sequential Events Recorder Report)..............................................
10-26
SHO Command (Show/View Settings).....................................................................
10-26
STA Command (Recloser Control Self-Test Status) ................................................
10-34
STA Command Row and Column Definitions..................................................
10-35
TAR Command (Display Relay Word Bit Status)....................................................
10-36
TIM Command (View/Change Time).......................................................................
10-38
TRI Command (Trigger Event Report).....................................................................
10-39
Access Level E (EZ) Commands ......................................................................................
10-39
BTT Command (Battery Test) ..................................................................................
10-39
SET EZ and SET FZ Commands (Change EZ Settings)...........................................
10-40
Access Level B Commands ..............................................................................................
10-41
BRE n Command (Preload/Reset Breaker Wear) .....................................................
10-41
CLO Command (Close Breaker)...............................................................................
10-43
GRO n Command (Change Active Setting Group)...................................................
10-43
OPE Command (Open Breaker)................................................................................
10-44
PUL Command (Pulse Output Contact)....................................................................
10-45
Access Level 2 Commands...............................................................................................
10-45
CON Command (Control Remote Bit)......................................................................
10-45
COP m n Command (Copy Setting Group)...............................................................
10-46
LOO Command (Loop Back)....................................................................................
10-46
PAS Command (View/Change Passwords) ..............................................................
10-46
SET Command (Change Settings) ............................................................................
10-47
STA C Command (Status Clear Command) .............................................................
10-48
VER Command (Show version information)............................................................
10-48
SEL-351P Recloser Control Command Summary....................................................................
10-50
TABLES
Table 10.1: Pinout Functions for EIA-232 Serial Ports 2, 3, and F........................................................10-2
Table 10.2: Terminal Functions for EIA-485 Serial Port 1 (Optional) ..................................................
10-3
Table 10.3: Serial Communications Port Pin/Terminal Function Definitions .......................................
10-6
Table 10.4: Serial Port Automatic Messages..........................................................................................
10-9
Table 10.5: Serial Port Command Summary........................................................................................
10-12
Table 10.6: SEL-351P Recloser Control Relay Word and Its Correspondence to TAR Command ....
10-37
Table 10.7: SEL-351P Recloser Control Remote Bit Control Subcommands .....................................
10-46
FIGURES
Figure 10.1: DB-9 Connector Pinout for EIA-232 Serial Ports...............................................................10-2