Seca CT8000P-2 - Connections; Back Panel

2 Introduction
2.6 Connections
Page 18
CT8000P-2
Art. no.: 2.511407 Rev.: a
2.6 Connections
2.6.1 Back panel
(1) Power supply unit connection 100 -220 VAC, 50/60 Hz, 1.3 A.
(2) Potential equalisation stud. The potential equalisation stud is used to equalise
the ground potential of the unit to that of any nearby mains-powered equipment.
Use the hospital or building common ground for all mains-powered units.
(3) RJ-45 Ethernet LAN connection (Local Area Network)
(4) 2 USB interfaces for the barcode scanner and USB memory sticks.
(5) 2x RS-232-DB9 (COM1 connections for ergometer, COM2  not supported)
(6) ECG patient cable connector DB15
(7) Kensington lock
 All externally connected hardware must be approved by seca. Connection of any
hardware not approved by seca is at the owner‘s risk. Moreover, the unit's
warranty may become invalid.
2
1
3
4
5
6
7
 The patient cable as well as the connector (6) comply with the safety standard CF
, i.e. they are fully floating and isolated and defibrillation protected.
 The unit is only CF rated and defibrillation protected if used with the original
SCHILER patient cable.