SEW-Eurodrive MOVIPRO Ethernet/IP - Page 177

13
Parameter setting
Parameterizing the communication and control unit "PFH-..."
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
177
No. Description
[2] The toolbar contains the icons for the following tasks:
• Add single axis
• Add multi-axis applications (not available for MOVIPRO
®
ADC)
• Delete axes
• Select axis-/device-independent functions (e.g. brake test)
• Start simulation (all axes/no axis)
• Save complete configuration (all axes)
[3] In this drop-down list, you select how the process data of the devices is ar-
ranged:
• Automatically: The devices are addressed sequentially.
• Manually: You can address the devices manually, thus providing for gaps in
the addressing. SEW‑EURODRIVE recommends using this setting only with
corresponding experience with addressing process data.
[4] This axes section displays the added axes in individual lines.
[5] This section displays the used/free process data words.
[6] With the buttons in the footer, you can scroll back and forth between the indi-
vidual program interfaces or switch to the start page.
2. If you are starting up a MOVIPRO
®
ADC with R15regenerative power supply, click
on the button [Function]. Otherwise, skip this step.
ð The following window is displayed.
18599188107
3. Activate the "MOVIPRO Repower" check box and confirm with the [Next] button.
16998413/EN – 12/2016