SEW-Eurodrive MOVIPRO Ethernet/IP - Page 180

13
Parameter setting
Parameterizing the communication and control unit "PFH-..."
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
180
No. Description
[4] In this area, you specify the assignment of the binary input and output terminals
of the device.
[5] This setting is only for devices with maintenance switch monitoring. This section
displays the used/free process data words.
5. Confirm the settings with [OK].
Load configuration into the device
WARNING
Risk of crushing if the drive starts up unintentionally.
Severe or fatal injuries.
• Disconnect the motor and all connected options from the power supply before
you start working.
• Secure the motor against unintended power-up.
Proceed as follows:
1. Configure the axes (→2178).
2. Click on the [Continue] button in the configuration interface.
ð The download interface is displayed.
18696433291
No. Description
[1] Use this button the save the configuration to a configuration file *.AppCon-
fig.zip on your PC. This way, you do not have to enter the values again for
future startups with the same configuration.
[2] Use this button to create a PDF file with a configuration report.
16998413/EN – 12/2016