SEW-Eurodrive MOVIPRO Ethernet/IP - Page 252

14
Service
List of power section errors
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
252
Code Meaning Response
(P)
Sub-
code
Meaning Possible cause Measure
25 EEPROM Rapid stop 0 Read or write
error on
EEPROM power
section
Error while accessing
EEPROM
• Restore factory
settings, perform
reset and reset
parameters
• Contact
SEW‑EURODRIVE
Service if the error
reoccurs
11 NV memory read
error
Internal NVRAM
13 NV memory chip
card
System module
defective
14 NV memory chip
card
Memory card de-
fective
16 NV memory ini-
tialization error
26 External
terminal
Emergency
stop (P)
0 External terminal Read external error
signal via program-
mable input
Eliminate respective
cause; reprogram ter-
minal if necessary
27 No limit
switches
Emergency
stop
0 Limit switches
missing or wire
break
• Open circuit/both
limit switches miss-
ing
• Limit switches are
swapped over in
relation to direction
of rotation of motor
• Check wiring of
limit switches
• Swap limit switch
connections
• Reprogram termin-
als
2 Limit switches re-
versed
3 Both limit
switches are act-
ive simultan-
eously
29 Limit
switch
reached
Emergency
stop
0 HW limit switch
reached
A limit switch has been
reached in IPOS
plus®
operating mode (only
with application
module).
• Check travel range
• Correct user pro-
gram
30 Emergency
stop
timeout
Immediate
stop
0 Timeout stop
emergency stop
rate
• Drive overloaded
• Emergency stop
ramp too short
• Check configura-
tion
• Extend emergency
stop ramp
16998413/EN – 12/2016