SEW-Eurodrive MOVIPRO Ethernet/IP - Page 33

5
Installation notes
Connection to the Ethernet network
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
33
Connection cable
NOTICE
The RJ45 socket can be damaged when inserting commercially available RJ45
patch cables without push-pull connector housing.
Damage to the RJ45 socket.
• Only plug suitable push-pull RJ45 mating connectors according to
IEC61076‑3‑117 into push-pull RJ45 sockets.
• Never use commercially available RJ45 patch cables without push-pull connector
housing. These plug connectors do not snap in place when they are plugged.
Use only shielded cables for this connection.
X4233_11, X4233_12: Ethernet interface
The following table provides information on this connection:
Function
• EtherNet/IP™ interface
• Modbus/TCP interface
Connection type
M12, 4-pin, female, D-coded
Wiring diagram
2
4
3
1
Assignment
No. Name Function
1 TX+ Transmit line (+)
2 RX+ Receive line (+)
3 TX- Transmit line (-)
4 RX- Receive line (-)
16998413/EN – 12/2016