SEW-Eurodrive MOVIPRO Ethernet/IP - Page 61

6
Configuration and startup of EtherNet/IP™
Project planning examples
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
61
14. Check if the process data correspond to the values that are displayed in the para-
meter tree of the MOVITOOLS
®
MotionStudio engineering software.
17894369291
ð When you move the mouse over the parameter, the tooltip shows the index,
subindex, factor, etc. of the parameter.
Access to device parameters with DLR support with RSLogix 5000 as of version V20
The following example describes the configuration of read and write access to the
device parameters with Studio 5000 Logix Designer, Version V24 (up to version V20:
RSLogix 5000).
You can access the device parameters as follows:
• via the 12-byte MOVILINK
®
parameter channel in process data
• via CIP message service
Access is possible with all device versions.
INFORMATION
This chapter describes the access to the device parameters via the CIP message
service. For information on the access via the 12-byte MOVILINK
®
parameter chan-
nel, refer to the "Application Configurator for CCU" manual.
16998413/EN – 12/2016