SEW-Eurodrive MOVIPRO Ethernet/IP - Page 64

6
Configuration and startup of EtherNet/IP™
Project planning examples
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
64
6. Open the tab [1].
16761256459
7. Click the button [2].
ð A module manager is displayed.
8. Via "I/O Configuration" > "Ethernet", select the target device with which you want
to establish communication.
9. Do not activate the check box [3]. Both the PLC and the device allow only a limited
number of connections.
10. Add the following additional "COP" command to the PLC program. The "COP"
command copies both INT variables "ReadParameter_Request.Data_LOW" and
"ReadParameter_Request.Data_HIGH" to a single DINT variable "ReadPara-
meter_Data":
9007214470315787
16998413/EN – 12/2016