SEW-Eurodrive MOVIPRO Ethernet/IP - Page 66

6
Configuration and startup of EtherNet/IP™
Project planning examples
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
66
14. Check if the process data correspond to the values that are displayed in the para-
meter tree of the MOVITOOLS
®
MotionStudio engineering software.
17894369291
ð When you move the mouse over the parameter, the tooltip shows the index,
subindex, factor, etc. of the parameter.
Writing parameters
Proceed as follows:
1. Create the user-defined data type "SEW_ParameterChannel". It allows you to or-
ganize the process data in a structure and simplifies access to the data elements.
INFORMATION
To ensure proper operation of the parameter channel, you must not change the order
of the variables. The data types must also match the figure.
9007214470249995
2. Create the following controller tags:
Name Data structure
WriteParameter_Start BOOL
WriteParameter_Response SEW_ParameterChannel
16998413/EN – 12/2016