SEW-Eurodrive MOVIPRO Ethernet/IP - Page 68

6
Configuration and startup of EtherNet/IP™
Project planning examples
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
68
6. Open the tab [1].
16761639563
7. Click the button [2].
ð A module catalog is displayed.
8. Via "I/O Configuration" > "Ethernet", select the target device with which you want
to establish communication.
9. Do not activate the check box [3]. Both the PLC and the device allow only a limited
number of connections.
10. Add the following additional COP command to the PLC program:
ð The COP command copies the DINT variable "WriteParameter_Data" to the
INT variables "WriteParameter_Request.Data_LOW" and "WriteParameter_Re-
quest.Data_HIGH".
9007214470254859
16998413/EN – 12/2016