SICK FLOWSIC600 - Page 157

Commissioning
FLOWSIC600 · Technical Information · 8010125 V 4.0 · © SICK AG 157
Subject to change without notice
Complete the following steps to configure the DataLogs:
 Go to the DataLogs page (select Meter / DataLogs from menu).
 Choose the Configuration tab (see  Figure 76).
 Switch the meter into Configuration Mode (choose "File / Configuration Mode" from the
menu).
 Use the drop down lists to select the parameter settings.
 Click the "Write to meter" button.
Figure 76 DataLogs Configuration tab
5.7.2.3 Disabling DataLogs
To disable a DataLog complete the following steps:
 Go to the DataLogs page (select Meter / DataLogs from menu).
 Choose the Configuration tab (see  Figure 76).
 Switch the meter into Configuration Mode (choose "File / Configuration Mode" from the
menu).
 Set the parameter "Storage cycle" to "disabled" for any DataLog that should be
disabled.
 Click the "Write to meter" button.
"Configuration"
tab