Siemens 7SC80 - Power System Data 1; Description

No. Information Type of
Informa-
tion
Comments
321 Warn Mem. Para. OUT Warn: Limit of Memory Parameter exceeded
322 Warn Mem. Oper. OUT Warn: Limit of Memory Operation exceeded
323 Warn Mem. New OUT Warn: Limit of Memory New exceeded
335 >GOOSE-Stop SP >GOOSE-Stop
373.3001 HotLineTag int. IntSP Hot Line Tag internal trigger
373.3002 HotLineTag ext. IntSP Hot Line Tag external trigger
444.3003 Bat. Test int. IntSP Battery Test internal trigger
502 Relay Drop Out SP Relay Drop Out
510 Relay CLOSE SP General CLOSE of relay
545 PU Time VI Time from Pickup to drop out
546 TRIP Time VI Time from Pickup to TRIP
2152 BATTERY INVALID OUT Invalid or no ext. battery connected
2155 BAT.CHARGE GOOD OUT Charge of battery is good
2156 BAT.CHARGE LOW OUT Charge of battery is low
2157 BATTERY EMPTY OUT Charge of battery is insufficient
2172 GPS ModuleError OUT GPS Module Error
2184 CT LPS mismatch OUT CT LoPo/LPS setting mismatch
2186 Error IO board OUT Error occurred on IO board
2240 Multi. routing OUT Several indications routed
2534 HotLineTag act. OUT Hot Line Tag is active, no operation
2535 >HotLineTag ext SP >Hot Line Tag external trigger
2537 >Start Bat.Test SP >Start of battery test
2538 BatTest aborted OUT Battery test aborted
2539 Execut. BatTest OUT Executing Battery test
2540 BatTest failed OUT Battery test failed
2541 BatRecov.failed OUT Battery recovery failed
2596 Test load act. OUT Battery test load active
6009 GPS time ok OUT Device is GPS time synchronized
6010 GPS antenna ok OUT GPS antenna is attached correctly
6095 >Block Bat Test SP >Block battery test
6096 Fill Lev1 reach OUT Thresh. reached event log fill level 1
6097 Fill Lev2 reach OUT Thresh. reached event log fill level 2
17566 Dist.CFC Src VI Disturbance CFC Source
Power System Data 1
Description
The device requires certain data regarding the network and substation so that it can adapt its functions to this
data depending on the application. This may be, for instance, nominal data of the substation and measuring
transformers, polarity and connection of the measured quantities, breaker properties (where applicable), etc.
There are also certain parameters that are common to all functions, i.e. not associated with a specific protec-
tion, control or monitoring function. The following section discusses this data.
2.1.3
2.1.3.1
Functions
2.1 General
48 SIPROTEC Compact, 7SC80, Manual
E50417-G1140-C486-A8, Edition 07.2017