Siemens HT6

10
03.04 Machine Data, NC Start-Up, System Parameters – Operating Area Start-Up
10
Machine Data, NC Start-Up, System Parameters – Operating Area Start-Up
10.1 Introduction............................................................................................................ 10-116
10.2 Machine data......................................................................................................... 10-117
10.2.1 General machine data........................................................................................... 10-118
10.2.2 Channel-specific machine data............................................................................. 10-120
10.2.3 Axis-specific machine data ................................................................................... 10-120
10.2.4 Drive configuration ................................................................................................ 10-121
10.2.5 Drive-specific machine data.................................................................................. 10-121
10.2.6 Display-specific machine data .............................................................................. 10-123
10.3 NC startup ............................................................................................................. 10-124
10.3.1 NCK address.........................................................................................................10-124
10.4 PLC ....................................................................................................................... 10-126
10.5 HMI startup............................................................................................................10-126
10.5.1 Language selection...............................................................................................10-127
10.5.2 Action log .............................................................................................................. 10-128
10.5.3 DOS editor ............................................................................................................10-128
10.6 Setting the system parameters ............................................................................. 10-129
10.6.1 LCD contrast ......................................................................................................... 10-130
10.6.2 Backlighting........................................................................................................... 10-130
10.6.3 Changing the language......................................................................................... 10-130
10.6.4 Processing the password...................................................................................... 10-131
 Siemens AG, 2004. All rights reserved.
SINUMERIK 840D/840Di/810D Operator's Guide Handheld Terminal 6 (BAH) - 03.04 Edition 10-115