10
Machine Data, NC Start-Up, System Parameters – Operating Area Start-Up 03.04
10.1 Introduction
10
10.1 Introduction
Danger
Changes in the startup operating area have a significant influence on
the machine. Incorrect parameterization can endanger lives and
cause the destruction of the machine.
Access rights to certain menus in the startup operating area may be
blocked by means of a keyswitch or password.
The functions are described which can be executed by the machine
operator with his access rights.
For more detailed information on the subject of startup for
• System personnel
• Machine manufacturers
• Service personnel
• Machine users (machine setters)
please refer to the following documentation:
References
/IAM/IM2, Start-up Guide, HMI Embedded, Section 11
/IAD/Start-up Guide, SINUMERIK 840D
/IAC/Start-up Guide, SINUMERIK 810D
Function
The following functions are available during startup:
• Changing machine data and setting them effective
• Startup of NC or HT 6
• PLC status and time
• Setting the system parameters
Prerequisites
IBN
• The operating area button has been pressed,
• The IBN softkey has been pressed.
Siemens AG, 2004. All rights reserved.
10-116 SINUMERIK 840D/840Di/810D Operator's Guide Handheld Terminal 6 (BAH) - 03.04 Edition
To Next Page
Loading...