Siemens HT6

4
03.04 Program operating area
4.2 Editor in normal mode
4
4.2.1 Edit program
Function
The working window Editor in Normal Mode is displayed unchanged;
only the softkey bar changes to the editing functions:
Edit Program working window
Operating sequence
Activate the editor functions with the softkeys as described below:
Mark block Start/discard text marking; softkey is inverted as long
as marking mode is switched on;
Copy block Copy the selected block to the clipboard;
Exit marking;
Insert block Insert the saved block (letters are lighter when no
block is saved);
Delete block Delete the selected block (after it has been saved),
New number Renumber blocks. Select block number input in
stages.
Other softkeys: same as in the Editor in Normal Mode working window
Further buttons
Recall Discard markings; → Editor in Normal Mode working
window
Cursor keys Move within the text
Backspace Deletes the character to the left of the cursor.
Insert Switch between insert/overtype modes
 Siemens AG, 2004. All rights reserved.
SINUMERIK 840D/840Di/810D Operator's Guide Handheld Terminal 6 (BAH) - 03.04 Edition 4-55