Siemens HT6

0
03.04 Preface
Intended use
0
Preface
Structure of the
Documentation
The SINUMERIK documentation is organized in 3 parts:
• General Documentation
• User Documentation
• Manufacturer/Service Documentation
Audience
This document is designed for machine tool users. The document
describes in detail all the technical facts an operator needs to
understand to operate the SINUMERIK 840D, 840Di, 810D control
systems.
Hotline
If you have any questions, please get in touch with our hotline:
A&D Technical Support
Phone.: +49 (0) 180 5050 - 222
Fax: +49 (0) 180 5050 - 223
If you have any questions about the documentation (suggestions,
corrections etc.), please send a fax or e-mail to:
Fax: +49 (0) 9131 98 - 2176
E-mail: motioncontrol.docu@erlf.siemens.de
Fax form: See the reply form at the end of the document.
Internet address
http://www.siemens.com/motioncontrol
SINUMERIK 840D
powerline
SINUMERIK 810D
powerline
Since 09.2001, improved-performance versions of
• SINUMERIK 840D powerline and
• SINUMERIK 840DE powerline (export version)
have been available. The hardware description below contains a list
of the available powerline modules:
References: /PHD/ SINUMERIK 840D Configuration Manual
Since 12.2001, improved-performance versions of
• SINUMERIK 810D powerline and
• SINUMERIK 810DE powerline (export version)
have been available. The hardware description below contains a list
of the available powerline modules:
References: /PHC/ SINUMERIK 810D Configuration Manual
Validity
Thie Operator’s Guide applies to the following controls:
SINUMERIK 840D SINUMERIK 840Di SINUMERIK 810D
with the handheld terminal (HT) 6, SW 6.4.
 Siemens AG, 2004. All rights reserved.
SINUMERIK 840D/840Di/810D Operator's Guide Handheld Terminal 6 (BAH) - 03.04 Edition v