Siemens HT6

10
Machine Data, NC Start-Up, System Parameters – Operating Area Start-Up 03.04
10.2 Machine data
10
Operating sequence
Select the machine data and activate the desired function with the
corresponding softkey:
Motor controller New softkey bar is displayed
(See subsection: "Further buttons")
Boot file New softkey bar is displayed
(See subsection: "Further buttons")
Further buttons
Drive -/+ Displays the previous/next drive
Motor controller
The following softkeys are available:
Calculate Calculate parameter(s)
Calc. contr. Convert control paramaters (with safety
prompt: No, Yes)
Boot file
The following softkeys are available:
Del. boot file Deletes the boot file
(with safety prompt: Cancel, Delete All, Yes)
Save boot file Saves the boot file
(with safety prompt: Cancel, Save All, Yes)
Operating sequence
• Select or deselect via the SELECT key
• Press the OK softkey
The following safety prompt is then displayed:
Attention!
Calculating the controller data will stop the drives.
Any setting adjustments will be reset.
Press the OK softkey again to start the calculation.
 Siemens AG, 2004. All rights reserved.
10-122 SINUMERIK 840D/840Di/810D Operator's Guide Handheld Terminal 6 (BAH) - 03.04 Edition