Siemens HT6

A
Appendix 03.04
C References
A
/FB3/
SINUMERIK 840D/840Di/810D (03.04 edition)
Description of Functions Special Functions (Part 3)
(the various manuals are listed below)
Order number: 6FC5297-6AC80-0BP2
F2 3-Axis to 5-Axis Transformation
G1 Gantry Axes
G3 Clock Times
K6 Contour Tunnel Monitoring
M3 Coupled Axes and ESR
S8 Constant workpiece speed for centerless grinding
S9 Setpoint Circuit (S9)
T3 Tangential Control
TE0 Installation and Activation of Compile Cycles
TE1 Distance Control
TE2 Analog Axes
TE3 Speed/Torque Coupling Master-Slave
TE4 Handling Transformation Package
TE5 Setpoint Exchange
TE6 MKS Coupling
TE7 Resynchronization - Retrace Support
TE8 Pulse-Independent Path-Synchronized Switching Signal Output
V2 Preprocessing
W5 3D Tool Radius Compensation
/FBA/
SIMODRIVE 611D/SINUMERIK 840D/810D (03.04 edition)
Description of Functions Drive Functions
(the various sections are listed below)
Order number: 6SN1197-0AA80-1BP0
DB1 Operating Messages/Alarm Responses
DD1 Diagnostic Functions
DD2 Speed Control Loop
DE1 Extended Drive Functions
DF1 Enable Commands
DG1 Encoder Parameter Settings
DL1 Linear Motor MD
DM1 Calculating Motor/Power Section Parameters and Controller Data
DS1 Current Control Loop
DÜ1 Monitors/Limitations
/FBAN/
SINUMERIK 840D/SIMODRIVE 611 DIGITAL (02.00 edition)
Description of Functions ANA MODULE
Order number: 6SN1197-0AB80-0BP0
/FBD/
SINUMERIK 840D (07.99 edition)
Description of Functions Digitizing
Order number: 6FC5297-4AC50-0BP0
DI1 Start-Up
DI2 Scan with Tactile Sensor (scancad scan)
DI3 Scan with Laser (scancad laser)
DI4 Milling Program Generation (scancad mill)
/FBDM/
SINUMERIK 840D/840Di/810D (09.03 edition)
Description of Functions NC Program Management
DNC Machine
Order number: 6FC5297-1AE81-0AP0
 Siemens AG, 2004. All rights reserved.
A-174 SINUMERIK 840D/840Di/810D Operator’s Guide Handheld Terminal 6 (BAH) - 03.04 Edition