1PosInc/Digital
3.10 Technical Specifications
ET 200S Positioning
Operating Instructions, 05/2007, A5E00124871-04
111
Technical Data of the 1PosInc/Digital
Output current
• 0 signal (leakage current)
• 1 signal
– Rated value
– Permitted range
≤ 0.3 mA
0.5 A
7 mA to 0.6 A
Switch rate
• Resistive load
• Inductive load
• Lamp load
100 Hz
2 Hz
≤ 10 Hz
Lamp load ≤5 W
Output delay (resistive load, output current 0.5 A)
• At 0 to 1
• At 1 to 0
typ. 150 µs
typ. 150 µs
Short-circuit protection of the output Yes
Threshold on 0.7 A to 1.8 A
Inductive extinction Yes; L+ -(55 to 60 V)
Digital input control Yes
Cable lengths
• Unshielded
• Shielded
600 m
1000 m
Encoder signals
• Level
• Terminating resistance
• Differential input voltage
• Max. frequency
• Galvanic isolation from ET200S bus
After RS 422
330 Ω
min. 1 V
500 kHz
Yes
Length of cable
• Shielded
Max. 50 m
Status, Diagnostics
Change in actual value (up)
Change in actual value (down)
Status display positioning in operation
Status display DI0 (minus hardware limit switch)
Status display DI1 (plus hardware limit switch)
Status display DI2 (reducing cam)
Group error on 1PosInc/Digital
Diagnostic information
UP LED (green)
DN LED (green)
LED POS (green)
LED 9 (green)
LED 13 (green)
LED 14 (green)
SF LED (red)
Yes
Response Times
Update rate for feedback messages
Response time at the switchover or switch-off point
Latch response time
2 ms
Output delay + 30 µs
Typ. 400 µs
To Next Page
Loading...
