Siemens SIMATIC ET 200S - Figure 2-1 Terminal Assignment for the Example

1STEP 5V/204kHz
2.2 Example : Commissioning 1STEP 5V/204kHz
ET 200S Positioning
Operating Instructions, 05/2007, A5E00124871-04
17
Installation, Wiring, and Fitting
1. Install and wire the TM-E15S24-01 terminal module (see the following figure).
2. Connect the 1STEP 5V/204kHz to the terminal module (you will find detailed instructions
on how to do this in the
Distributed I/O Device manual).
You can find out how to wire the power unit and the stepping motor in the relevant product
manuals.

)067(3'5,9(6,0267(3
',5B1
',5
6)
67(3
9N+]
'&$%
(6



9'&
', 5()
9'&
70(6
326
5()
5'<

33
''
&DEOHVEHWZHHQWKHWHUPLQDOPRGXOHDQGWKHSRZHU
XQLWPXVWEHWZLVWHGLQSDLUVDQGVKLHOGHG
3XOVHV
3XOVHB1
3XOVH
'LUHFWLRQ
3RZHU8QLW SKDVHVWHSSLQJPRWRU LQWKH6,0267(3UDQJH
Figure 2-1 Terminal Assignment for the Example