Siemens SIMATIC ET 200S - Parameters and Settings

1STEP 5V/204kHz
2.5 Fundamentals of Positioning
ET 200S Positioning
Operating Instructions, 05/2007, A5E00124871-04
25
2.5.2 Parameters and Settings
Required Information
To ensure optimum interplay between the individual components, you must provide the
1STEP 5V/204kHz with information:
● One time: during parameter configuration using your configuration software
– Base Frequency F
b:
– Multiplier n for setting the start-stop frequency F
ss
– Multiplier i for setting the acceleration/delay in steps
● In operation: movement of the motor by means of a positioning job in your user program
– Multiplier G for the velocity/output frequency F
a
– Reduction factor R for the assigned parameters base frequency F
b
– Distance (number of pulses to be emitted)
– Mode and
– Direction selection as start
● In operation: to adjust to different load conditions as a parameter assignment request in
your user program
– Base Frequency F
b:
– Multiplier n for setting the start-stop frequency F
ss
– Multiplier i for setting the acceleration/delay in steps
See also
Traversal Curve of the 1STEP 5V/204kHz (Page 26)
Setting the Base Frequency (Page 29)