1PosInc/Analog
4.2 Brief Instructions on Commissioning the 1PosInc/Analog
ET 200S Positioning
Operating Instructions, 05/2007, A5E00124871-04
115
Installation, Wiring, and Fitting
Install and wire the TM-E30S44-01 terminal module. Insert the 1PosInc/Analog in the
terminal module (you can find detailed instructions in the
Distributed I/O Device
manual).
Table 4-1 Terminal assignment of the 1PosInc/Analog
Terminal assignment View Remarks
Connection of the Incremental
Encoder with 5 V Differential
Signals: Terminals 1-8
Connection of the Switches and
the Drive: Terminals 9-16
1: A 9: IN0 Minus limit switch
5: /A
Track A
13: IN1 Plus limit switch
3: B 14: IN2 Reducing cam; latch
signal
7: /B
Track B
10: 24 VDC Encoder supply for
the switches
2: 24 VDC 12: QV+
6: M
Voltage supply for
incremental encoder
16: M
ana
Analog output ± 10
or 0 V to 10 V to
connect the drive
4: N 11: OUT
6)
326
(6'-$%
326
83 '1
,QF
$
$
%
%
1
1
/
0
,QF$QDORJ
8:/N
Track N; optional zero
mark
15: M
Digital output DO for
direct control or as a
directional signal for
the drive
To Next Page
Loading...
