Siemens SIMATIC ET 200S - Parameters for power modules

1PosUniversal/Digital
7.1 Product overview
ET 200S Positioning
308 Operating Instructions, 05/2007, A5E00124871-04
● Diagnostics
– Encoder monitoring
– Load voltage monitoring
● Firmware update
1)
– In order to extend the functionality and eliminate errors, firmware updates can be
downloaded to the operating system memory of the 1PosU by means of the STEP 7
HW Config software.
Note
Caution
When the firmware update is started, the old firmware is deleted. If the firmware update is
interrupted or aborted for any reason, the 1PosU can subsequently no longer function.
Start the firmware update again and wait until it has been completed successfully.
● Information function
1)
– Hardware version
– Firmware version
– Serial number
1)
The function is only possible if the used header module supports the required system
services
Configuration
In order to configure the 1PosU use one of the following
● A DDB file (http://www.ad.siemens.de/csi/gsd) or
● STEP 7 as from Version V5.3 SP 2 or with the HSP (hardware support package from the
Internet) as from STEP 7 Version V5.2 SP 1