Siemens SIMATIC ET 200S - Guide; Special note; Recycling and disposal

Table of contents
ET 200S Positioning
Operating Instructions, 05/2007, A5E00124871-04
9
Tables
Table 2-1 Terminal Assignment of the 1STEP 5V/204kHz ..........................................................................
21
Table 2-2 Ranges for the Start-Stop Frequency, Output Frequency, and Acceleration ..............................
30
Table 2-3 Assignment of the Inputs (I): Feedback interface ........................................................................
44
Table 2-4 Assignment of the Outputs (O): Control interface........................................................................
45
Table 3-1 Causes of Errors for POS_ERR.................................................................................................
102
Table 3-2 Causes of Errors for JOB_ERR .................................................................................................
103
Table 4-1 Terminal assignment of the 1PosInc/Analog .............................................................................
115
Table 4-2 Terminal assignment of the 1PosInc/Analog .............................................................................
120
Table 4-3 Interpretation of Bits 5 and 6......................................................................................................
132
Table 4-4 Causes of Errors for POS_ERR.................................................................................................
174
Table 4-5 Causes of Errors for JOB_ERR .................................................................................................
175
Table 5-1 Causes of Errors for POS_ERR.................................................................................................
231
Table 5-2 Causes of Errors for JOB_ERR .................................................................................................
232
Table 6-1 Terminal assignment of the 1PosSSI/Analog ............................................................................
243
Table 6-2 Terminal assignment of the 1PosSSI/Analog ............................................................................
248
Table 6-3 Interpretation of Bits 5 and 6......................................................................................................
260
Table 6-4 Causes of Errors for POS_ERR.................................................................................................
294
Table 6-5 Causes of Errors for JOB_ERR .................................................................................................
294
Table 7-1 Terminal assignment of the 1PosU............................................................................................
310
Table 7-2 Terminal Assignment of the 1PosU ...........................................................................................
315
Table 7-3 Causes of Errors for POS_ERR.................................................................................................
365
Table 7-4 Causes of Errors for JOB_ERR .................................................................................................
366