Siemens SIMATIC NET IE/AS-INTERFACE LINK PN IO User Manual

5 Display / WBM Configuration
91
IE/AS−INTERFACE LINK PN IO as of hardware version 1, as of firmware version V2.0
Release 08/2018
C79000−G8976−C216−03
Parameter Function
Error Displays the status currently being signaled by the slave (check mark):
S Address/ID1 volatile
S I/O / parity error
S End bit error
S EPROM error
Shows how many errors of a type have occurred.
The following errors are listed:
S Slave failure
S Missing slave frame
S Bad slave frame
S Slave I/O error
S Slave protocol error
S Bad master frame
Some errors occur in tandem (for example slave failure + missing/bad slave
frames).
Note
To find out which error messages the slave supports, refer to the slave data sheets.
Reset With the “Reset” button, you can reset the error counter of the slave to 0.
5.2.15.2 Configuration
For the content and functions, refer to Section 5.2.14.2.

Siemens SIMATIC NET IE/AS-INTERFACE LINK PN IO Specifications

General

Brand	Siemens
Model	SIMATIC NET IE/AS-INTERFACE LINK PN IO
Category	Control Unit
Language	English