6.5 Options for Drive Menu (2) - rst part
Note
Changing Drive Parameters
Only Siemens trained personnel are authorized to change drive parameters.
Familiarize yourself with the safety notes in Section Safety Notes for Parameter Changes and
preferentially contact Siemens customer service before changing the default conguration.
The Drive Menu (2) consists of the following submenus:
• Drive Parameter Menu (2000)
• Speed Setup Menu (2060)
• Torque Reference Menu (2210)
• Speed Ramp Setup Menu (2260)
• Critical Frequency Menu (2340)
• Spinning Load Menu (2420)
• Conditional Timer Menu (2490)
• Cell Menu (2520)
• AP Settings Menu (2585)
• Synchronous Transfer Menu (2700)
• External I/O Menu (2800)
• Internal I/O Menu (2805)
• Output Connection Menu (2900)
• High Starting Torque Menu (2960)
• Watchdog Menu (2970)
These menus are explained in the tables that follow.
NOTICE
IP Address Duplication
Duplicating IP addresses will cause unintended communication issues that will lead to incorrect
drive operation.
To avoid duplication of IP addresses, ensure that the IP addresses of the drive and the PC are NOT
the same before connecting an external PC to the Ethernet connection of the drive.
NOTICE
Setting Rated Values Incorrectly
Rated values must be set according to actual rated values.
Failure to do so can result in unintended performance and may disable drive protections.
Parameter Assignment/Addressing
6.5 Options for Drive Menu (2) - rst part
NXGPro+ Control Manual
100 Operating Manual, A5E50491925A
To Next Page
Loading...
