Software user interface
9
Interfaces for Changing and Tuning Controls
Use one of the following methods to change parameters in the drive:
• SIMATIC keypad
• Multi-language keypad
• PC-based drive tool
• Via networks.
This chapter discusses the navigation of the multi-language keypad and the standard keypad in
detail, and introduces the more advanced external interface of the PC-based drive tool.
The fourth listed method involves changing parameters by means of networks. It involves
programming on an interconnected platform, e.g. an external PLC. For more information refer
to the NXGPro+ Communication Manual (A5E50226719).
NXGPro+ Control Manual
Operating Manual, A5E50491925A 339
To Next Page
Loading...
