Siemens SINAMICS PERFECT HARMONY GH180 - Field Bus Protection; USB Connection; Secure USB System Keys

The maintenance Ethernet connection is located on the front door of the GH180 drive.
Note
Only use the maintenance Ethernet connection for maintenance performed at the drive
location.
9.4.7 Field Bus Protection
Some 󹪝eld bus networks such as Modbus TCP and Ethernet/IP™ are Ethernet based. Ethernet
based 󹪝eld bus networks must not be connected to the controller’s maintenance Ethernet
network.
The GH180 supports parameter modi󹪝cation by means of 󹪝eld bus networks which must be
enabled using parameter selection. Unless enabled, no parameters may be read or written by
means of 󹪝eld bus networks.
9.4.8 USB Connection / Secure USB System Keys
USB Connection / Secure USB System Keys
The GH180 drive supports the use of USB 󹪞ash drives for log retrieval, SOP 󹪝le retrieval,
parameter retrieval, and secure USB system key creation and usage. Great care should be taken
with any exchangeable storage media to ensure no malicious software is allowed to reside on
this media.
WARNING
Risk of death due to software manipulation when using exchangeable storage media
Storing 󹪝les on exchangeable storage media poses an increased risk infection from malicious
software viruses and malware. Incorrect parameter assignment can cause machines to
malfunction, which can lead to death or injury to personnel.
• Be sure to protect 󹪝les stored on exchangeable storage media
• Use appropriate software protection measures such as virus scanners.
USB Connection
Note
Veri󹪝cation for Flash Disk properties
Each item list can be veri󹪝ed on a Windows PC.
Software user interface
9.4 Security Measures
NXGPro+ Control Manual
Operating Manual, A5E50491925A 395