Siemens SINAMICS PERFECT HARMONY GH180 - Display

Key Combination Description
6+,)7
Go to the bottom item of the currently selected menu, submenu or pick list.
6+,)7
When editing a value that has been changed from its factory default, this key sequence returns the
value to its factory default.
9.1.12 Display
After power up or reset, the Siemens identi󹪝cation and software version number is displayed for
a few seconds. Afterwards, the meter display is shown by default. The default meter display is
the starting point of the menu system. This display remains active until keys are pressed.
Re-displaying the Version Number
Use the display version number (8090) function in Meter Menu (8) to re-display the version
number.
The version number is displayed on the identi󹪝cation/version screen.




+$1'
,727
9/76
530
'(0'
02'(
V e r s i o n # . # . # D a t e
S I N A M I C S P e r f e c t H a r m o n y
Figure 9-6 SINAMICS Identi󹪝cation/Version Screen and Meter Display
Note
The meter display shown may appear di󹪜erently depending upon the metering parameters
selected.
Description of the Meter Display
The meter display screen contains 󹪝ve 󹪝elds that are monitored and updated dynamically.
• MODE: operational mode
• DEMD: velocity demand
• RPM: calculated revolutions per minute
• VLTS: motor voltage
• ITOT: total output current
The value or state of each 󹪝eld is shown dynamically in the second column of the display.
Software user interface
9.1 SIMATIC Keypad
NXGPro+ Control Manual
Operating Manual, A5E50491925A 355