Siemens SINAMICS PERFECT HARMONY GH180 - Summary of Common Shift Key and Arrow Key Sequences

Perform the following steps:
1. Press the [SHIFT] key followed by the right arrow key [⇒]. The display prompts you for the
desired ID number.
2. Enter the desired ID number using the numeric keys on the keypad.
If the number is a valid ID number and the current security level permits access to that item, then
the desired item will be displayed.
Note
Accessing higher security level menus
If you request access to a menu number that is assigned a higher security level than the current
security level, the drive will prompt for the appropriate security level code.
Within the menu structure, when not in edit mode, the right arrow acts like the [ENTER] key upon
the menu item displayed while the left arrow climbs the menu hierarchy.
9.1.11 Summary of Common Shift Key and Arrow Key Sequences
Menu System Structure
The menu system consists of the main menu and submenus that branch from the main menu
or other submenus. Parameters are contained within these menus.
While navigating inside a parameter list or pick list, select [CANCEL] to exit to the menu.
While inside any menu select [CANCEL] to exit to the default meter display.
Table 9-3 Summary of common [SHIFT] key and arrow key sequences
Key Combination Description

02725
6+,)7
Speed Menu to the Motor Menu. Access from the default meter display.
Enter hexadecimal "A" from value edit and security prompts.

'5,9(
6+,)7
Speed Menu to the Drive Menu. Access from the default meter display.
Enter hexadecimal "B" from value edit and security prompts.

67$%
6+,)7
Speed Menu to the Stability Menu. Access from the default meter display.
Enter hexadecimal "C" from value edit and security prompts.

$872
6+,)7
Speed Menu to the Auto Menu. Access from the default meter display.
Enter hexadecimal "D" from value edit and security prompts.

0$,1
6+,)7
Speed Menu to the Main Menu. Access from the default meter display.
Enter hexadecimal "E" from value edit and security prompts. Right arrow [⇒] also enters at this point
from outside of the menu system.
Software user interface
9.1 SIMATIC Keypad
NXGPro+ Control Manual
Operating Manual, A5E50491925A 353