Siemens SINAMICS PERFECT HARMONY GH180 - Security Access Levels and Codes

6.13 Security Access Levels and Codes
Note
Changing default access codes
Access codes allow you to access and change the default security settings of the drive control.
Menu options above security level 5 are intended only for trained Siemens personnel during
commissioning or servicing.
Siemens recommends changing access codes to provide a higher level of security and to prevent
tampering.
Access the Security Edit Menu (5000) to change the factory default security settings. When the
drive is con󹪝gured for security level 7 access, the Security Edit Menu (5000) is visible from the
Main Menu (5). Functions within this menu are used to:
• set the security levels for menu items
• hide menu items
• prevent changes to speci󹪝c parameters.
The Security Edit Functions Menu (5000) contains security functions described in the table
below.
Table 6-82 Default Security Access Levels and Access Codes
Access Level Default Access Code Level of Security
0 None Minimum access
5 5555 Startup access for service and/or startup
7 7777 Advanced access for troubleshooting
Parameter Assignment/Addressing
6.13 Security Access Levels and Codes
NXGPro+ Control Manual
152 Operating Manual, A5E50491925A