Siemens SINAMICS PERFECT HARMONY GH180 - Torque Mode Parameters

7RUTXH'HPDQG)URP$QDORJB2
7RUTXH'HPDQG)URP1HWZRUNB2
7RUTXH'HPDQG)URP0HQXB2
7RUTXH0RGHB2
$QDORJ,QSXW
,QGXVWULDO1HWZRUN
0HQX6HWWLQJ
Figure 8-27 Torque Demand Options
Depending on the source of the Torque Demand, the appropriate SOP 󹪞ags and menu settings
must be con󹪝gured. In all cases the TorqueMode_O 󹪞ag must be set TRUE to use torque mode,
and the necessary torque command established through the selected source.
8.21.2 Torque Mode Parameters
Parameters for Torque Mode
Refer to Torque Reference Menu (2210) in Section Options for Drive Menu (2) of
Chapter Parameter Assignment / Addressing for parameters associated with this function:
• SOP/menu control (2211)
• Torque setpoint (2220)
• Holding torque (2230)
• Torque ramp increase (2240)
• Torque ramp decrease (2250)
• Torque command scaler (2242)
Advanced Operating Functions
8.21 Torque Mode
NXGPro+ Control Manual
320 Operating Manual, A5E50491925A