Siemens SINAMICS PERFECT HARMONY GH180 - ML Summary of Common Shift Key and Arrow Key Sequences (T76)

Order Code Meaning Description
8 KYPD Keypad speed demand The drive speed demand source is the keypad.
9 TEST Speed/Torque test The drive is in a speed or torque test mode.
10 LOS Loss of Signal The drive 4 to 20 mA analog input signal has dropped below a prede󹪝ned
setting.
11 NET1 Network 1 Indicates drive is being controlled from Network 1.
12 NET2 Network 2 Indicates drive is being controlled from Network 2.
13 AUTO Automatic mode The SOP 󹪞ag AutoDisplayMode_O is set true usually to indicate drive is
receiving its speed demand from a source other than the keypad or net‐
work. Typically used with an analog input speed source. This mode is
entirely determined by setting the SOP 󹪞ag. It does not a󹪜ect NXG oper‐
ation.
14 HAND Hand mode Appears if the drive is running under normal conditions.
15 BRAK Dynamic Braking Indicates that dynamic braking is enabled.
16 DECL Decelerating (no braking) The drive is decelerating normally.
17 COAS Coasting to stop The drive is not controlling the motor and it is coasting to a stop due only
to friction.
18 TUNE Auto Tuning The drive is in a "Auto Tuning" mode used to determine motor character‐
istics.
19 FALT Drive fault active This mode is selected if any drive fault exists, but is not usually displayed
as the fault message is displayed instead. This is shown if the "Fault display
override" (8200) feature is enabled.
9.2.1.10 ML Summary of Common Shift Key and Arrow Key Sequences (T76)
Menu System Structure
The menu system consists of the main menu and submenus that branch from the main menu
or other submenus. Parameters are contained within these menus.
While navigating inside a parameter list or pick list, select [CANCEL] to exit to the menu.
While inside any menu select [CANCEL] to exit to the default meter display.
Table 9-11 Summary of common [SHIFT] key and arrow key sequences
Key Combination Description

02725
6+,)7
Speed Menu to the Motor Menu. Access from the default meter display.
Enter hexadecimal "A" from value edit and security prompts.

'5,9(
6+,)7
Speed Menu to the Drive Menu. Access from the default meter display.
Enter hexadecimal "B" from value edit and security prompts.

67$%
6+,)7
Speed Menu to the Stability Menu. Access from the default meter display.
Enter hexadecimal "C" from value edit and security prompts.
Software user interface
9.2 Multi-Language Keypad
NXGPro+ Control Manual
Operating Manual, A5E50491925A 387