Siemens SINAMICS PERFECT HARMONY GH180 - Uploading the SOP

10.8 Uploading the SOP
The need may arise to view and/or modify the installed SOP 󹪝le. This is done by communications
from the drive to an external PC, and is known as uploading. The tools for uploading the SOP are
contained in the Siemens ToolSuite of tools.
The SOP is uploaded to the DCR via Tool Suite - Drive Tool via Ethernet.
Uploading the SOP via serial Ethernet connection
Use the Drive Tool to upload the SOP via the Ethernet connection. Once a connection with the
drive is established, select the Upload System Program function from the Con󹪝guration Menu.
Refer to the NXGPro+ ToolSuite Software Manual (A5E03086439) for details about the Drive
Tool.
Operating the Software
10.8 Uploading the SOP
NXGPro+ Control Manual
438 Operating Manual, A5E50491925A