Siemens SINAMICS PERFECT HARMONY GH180 - Options for Drive Protect Menu (7) - Part 1

6.14 Options for Drive Protect Menu (7) - part 1
Note
Changing Drive Parameters
Only Siemens trained personnel are authorized to change drive parameters.
Familiarize yourself with the safety notes in Section Safety Notes for Parameter Changes and
preferentially contact Siemens customer service before changing the default con󹪝guration.
The Drive Protect Menu (7) consists of the following menu options:
• Input Protect Menu (7000)
• Single Phasing Menu (7010)
These menus are explained in the tables that follow.
Table 6-83 Drive Protect Menu (7) Parameters
Parameter ID Unit Default Min Max Description
Input protection 7000 Submenu Access the input protection parameters.
See Table Input Protect Menu (7000).
Drive IOC set‐
point
7110 % 150.0 50.0 175.0 Drive instantaneous over current setpoint
as a percentage of drive output rating.
This parameter sets a hardware based
comparator threshold on the main control
board.
Cell Overload
Level
7112 % 100.0 100.0 150.0 Cell current overload, as a percentage of
drive output rating, allowed for 1 minute
out of every 10 minutes.
Power Rollback
Enable
7114 Enable Enable Disable Enable Transformer Secondary Power Roll‐
back for bypass loading.
Auto reset ena‐
ble
7120 No Enable the reset of the drive after a fault.
Auto reset time 7130 sec 1 0 120 Adjust the time between the fault and its
automatic reset.
Auto reset at‐
tempts
7140 4 1 10 Set the number of attempts a drive will be
reset before a permanent shutdown.
Auto reset
memory time
7150 sec 10 1 1000 Set the amount of time between faults
that will clear the attempts counter.
Fault Reset 7160 Function Issue a drive fault reset when selected.
Thermal OT Roll‐
back
7170 Submenu Thermal over temperature rollback sub‐
menu.
Refer to Section Thermal Over Tempera‐
ture Rollback for a description of opera‐
tion.
Min Rollback
Level
7171 Function Minimum rollback level.
Rollback Ramp
Rate
7172 Function Rollback base rate.
Parameter Assignment/Addressing
6.14 Options for Drive Protect Menu (7) - part 1
NXGPro+ Control Manual
Operating Manual, A5E50491925A 153