Siemens SINAMICS PERFECT HARMONY GH180 - Options for Communications Menu (9)

6.18 Options for Communications Menu (9)
NOTICE
IP Address Duplication
Duplicating IP addresses will cause unintended communication issues that will lead to incorrect
drive operation.
To avoid duplication of IP addresses, ensure that the IP addresses of the drive and the PC are NOT
the same before connecting an external PC to the Ethernet connection of the drive.
Note
Changing Drive Parameters
Only Siemens trained personnel are authorized to change drive parameters.
Familiarize yourself with the safety notes in Section Safety Notes for Parameter Changes and
preferentially contact Siemens customer service before changing the default con󹪝guration.
The Communications Menu (9) consists of the following menu options:
• Network Control (9943)
• Network 1 Con󹪝gure (9900)
• Network 2 Con󹪝gure (9914)
• SOP Functionms (9110)
• TCP/IP (9300)
These menus are explained in the tables that follow.
Table 6-98 Communications Menu (9) Parameters
Parameter ID Unit Default Min Max Description
Serial port setup 9010 Submenu Access serial port setup parameters. See Table Serial Port
Setup Menu (9010).
Network Control 9943 Submenu
Refer to the NXGPro+ Communications Manual.
(A5E50226719)
Network 1 Con󹪝gure 9900 Submenu
Network 2 Con󹪝gure 9914 Submenu
Fast Access Enable
(Not Available)
9971 O󹪜 Enable fast access fo two consecutive registers for PLC
Control.
*
Parameter Assignment/Addressing
6.18 Options for Communications Menu (9)
NXGPro+ Control Manual
Operating Manual, A5E50491925A 167