Siemens SINAMICS PERFECT HARMONY GH180 - Options for Meter Menu (8)

6.17 Options for Meter Menu (8)
Note
Changing Drive Parameters
Only Siemens trained personnel are authorized to change drive parameters.
Familiarize yourself with the safety notes in Section Safety Notes for Parameter Changes and
preferentially contact Siemens customer service before changing the default con󹪝guration.
The Meter Menu (8) consists of the following menu options:
• Display Parameters Menu (8000)
• Hour Meter Setup Menu (8010)
• General Drive Parameters Menu (Set Time, Software Version, Language, Output Units)
• Input Harmonics Menu (8140)
• High Speed Recorder Parameters (8220)
These menus are explained in the following tables.
Table 6-92 Meter Menu (8) Parameters
Parameter ID Units De‐
fault
Min Max Description
Display parameters 8000 Submenu Access the display parameters. See Table Dis‐
play Parameters Menu (8000).
Hour meter setup 8010 Submenu Access the hour meter setup parameters. See
Table Hour Meter Setup (8010).
Input harmonics 8140 Submenu Access the input harmonics parameters. See Ta‐
ble Input Harmonics Menu (8140). Refer to
chapter High Speed Recorder in the ToolSuite
Pro+ Manual (A5E03086439) for full descrip‐
tion of the High Speed Recorder functionality.
High Speed Recorder
Parameters
8220 Submenu Access High Speed Recorder parameters. See
Table High Speed Recorder Parameters Menu
(8220).
Fault display override 8200 O󹪜 Enable or disable the display of fault/alarm mes‐
sages on the keypad.
Set the clock time 8080 Function Change the time and date of the real-time clock
chip.
Display version num‐
ber
8090 Function Display the installed version of 󹪝rmware.
Customer order 8100 0 0 9999999 View the 7 digit customer order number. This
parameter is now obsolete due to ID 8101 on
Version 4.1.0 code.
Customer order 8101 0 0 9999999999 View the 10 digit customer order number. This
parameter replaces ID 8100 on Version 4.1.0
code and later.
Customer drive 8110 1 0 9999999 View the customer drive number.
Parameter Assignment/Addressing
6.17 Options for Meter Menu (8)
NXGPro+ Control Manual
Operating Manual, A5E50491925A 161