Siemens SINAMICS PERFECT HARMONY GH180 - Options for Auto Menu (4)

6.11 Options for Auto Menu (4)
Note
Changing Drive Parameters
Only Siemens trained personnel are authorized to change drive parameters.
Familiarize yourself with the safety notes in Section Safety Notes for Parameter Changes and
preferentially contact Siemens customer service before changing the default con󹪝guration.
The Auto Menu (4) consists of the following menu options:
• Speed Pro󹪝le Menu (4000)
• Analog Input Menu (4090)
• Analog Outputs Menu (4660)
• Speed Setpoint Menu (4240)
• Incremental Speed Setup Menu (4970)
• PID Select Menu (4350)
• Comparator Setup Menu (4800)
These menus are explained in the tables that follow.
Table 6-61 Speed Pro󹪝le Menu (4000) Parameters
Parameter ID Unit Default Min Max Description
Entry point 4010 % 0.0 0.0 200.0 Set the percent of speed command at which the drive be‐
gins, following the speed command.
Exit point 4020 % 150.0 0.0 275.0 Set the percent of speed command at which the drive
stops, following the speed command.
Entry speed 4030 % 0.0 0.0 200.0 Set the speed command to which the drive accelerates
when given a start command, when the speed pro󹪝le func‐
tion is enabled.
Exit speed 4040 % 150.0 0.0 275.0 Set the speed command that the drive reaches at the exit
point.
Auto o󹪜 4050 % 0.0 0.0 100.0 Set the level of command at which the drive turns o󹪜.
Delay o󹪜 4060 sec 0.5 0.5 100.0 Set a time delay between the time the command reaches
the auto o󹪜 point and the time the drive shuts o󹪜.
Auto on 4070 % 0.0 0.0 100.0 Set the level of command at which the drive turns on.
Delay on 4080 sec 0.5 0.5 100.0 Set a time delay between the time the command reaches
the auto on point and the time the drive starts.
Parameter Assignment/Addressing
6.11 Options for Auto Menu (4)
NXGPro+ Control Manual
Operating Manual, A5E50491925A 137