Figure 9-73 Location of shift mode indicator on the display
The SHIFT function is a toggle. Press [SHIFT] again before pressing any other key to remove the
pending SHIFT function and clear the arrow indicator.
Common [SHIFT] key functions
• Entering speed menus by pressing [SHIFT] plus the appropriate Speed Menu key from the
default meter display.
• Using the [CANCEL] function, by pressing [SHIFT] + [ENTER] in sequence.
• Entering hex values A to F, by pressing [SHIFT] + [1] to [SHIFT] + [6] when editing values or
entering security code.
• Accessing menus, parameters or pick lists based on ID numbers, by pressing [SHIFT] + [⇒].
• Returning to the top of the current menu or submenu, by pressing [SHIFT] + [⇑].
• Going to the bottom of the menu or submenu, by pressing [SHIFT] + [⇓].
• Resetting the current security level to 0, by pressing
[SHIFT] + [⇐] + [SHIFT] + [⇐] + [SHIFT] + [⇐] from the default meter display.
• Setting a parameter value back to its factory default, by pressing [SHIFT] + [⇐], while in the
parameter edit function.
A summary of [SHIFT] key sequences is listed in Section Summary of Common [SHIFT] key
sequences.
9.6.7 ML Arrow Keys (T76)
There are four arrow keys on the keypad.
The up and down arrow keys [⇑] and [⇓] are located in the upper right corner of the keypad.
The left and right arrow keys [⇐] and [⇒] are located on the lower row of the keypad.
Common arrow key functions
• Navigating through the menu structure
• Scrolling through lists of parameters
• Incrementing or decrementing parameter values in edit mode.
• Manually advancing to the next digit in edit mode.
• Increasing and decreasing the desired velocity demand of the drive in local manual mode.
Software user interface
9.6 ML Keypad
NXGPro+ Control Manual
416 Operating Manual, A5E50491925A
To Next Page
Loading...
